IPMS LogoInternational Plastic Modelers' Society / USA

IPMS LogoInternational Plastic Modelers' Society / USA

IPMS LogoIPMS/USA

IPMS LogoIPMS/USA

Continuing Fabrication and Painting

  1. Airbrush clear gloss coat on the complete model in preparation for decals and set aside to dry thoroughly.
  2. Airbrush silver on the propeller components A7, the out side of the blades, (Facing away from the pilot) A21, (Rear spinner) and B39 (Landing hook) and set aside to dry.
  3. Mask the anti-glare areas that are inside the canopy and windscreen for airbrushing using the same paint as the cockpit interior. Airbrush and set aside to dry
  4. Install P/N B34 (Cockpit headrest) and B31 (Loop antenna).
  5. Apply future to the inside of the canopy and apply heat to dry.
  6. Apply Future to the outside of the canopy and apply heat to dry. Do not overheat the canopy plastic as you may melt or deform the canopy.